• No Comments

This is a Kenwood VHF repeater, model number TKR This is a 32 ch, 50 watt repeater that operates in the Mhz range. Repeater is capable of both. Find great deals for Kenwood Tkr Repeater VHF 16ch MHz 50 Watts. Shop with confidence on eBay!. TKR) TCXO modules, % duty RF power amplifier output is 50W (at 50 % duty) a TKR is 40W (at. 50% duty). make Kenwood’s TKR/

Author: Moogushura Bar
Country: Reunion
Language: English (Spanish)
Genre: Marketing
Published (Last): 28 March 2007
Pages: 347
PDF File Size: 4.34 Mb
ePub File Size: 13.84 Mb
ISBN: 132-8-67197-478-8
Downloads: 55850
Price: Free* [*Free Regsitration Required]
Uploader: Dumuro

Base Station & Repeater

The rec goes down to. Just asking for it to be blown out as I’ve seen time and time again. We use these repeaters in commercial radio sites. The only negative thing I found was that the audio level on the discriminator is extremely low. Plus why amplify noise before the duplexers? FM VHF repeater with cw controler build in. If anyone has a question on the programing on a kenwood tkr or let me know at kc9gmh15 yahoo. For use with voting systems, supplies Ohm balanced 2-wire audio, occupies 1 RU.

Kenwood Tkr-750-1 Repeater VHF 16ch 146-174 MHz 50 Watts

And yes, I checked the alignment and it was correct. That takes about 5 minutes to do, but should be done for best sensitivity. Patent and other rights reserved. Contact tkr-7550 site with comments or questions. We’ve had the pre amps and TRK’s in service about 2 years with no issues.


Cabinet Fan Top Assembly. We have 7 of these repeaters on our linked repeater system, they have been operating flawlessly for 5 years or so. Yes my kenwood was on mhz area.

I have program’d all 3. We have had the Kenwood TKR on the air for about 18 months and have not had any problems. Includes five pre-drilled openings and grommets. Incompatible with W amplifier option.

In the front part of the rec there are 5 coils you have to tune with a signal gen. Cabinet Solid Floor Panel. May not be the best out there but, they get the job done for us. Let the duplexers filter out some of the noise and protect the pre amp.

Take it out and you have the same sensitivity of the Kenwood. These have a built in DTMF controller, which can be configured to control internal functions, or drive external accessories or relays.

The 25 pin connector gives you everything you need. They have been in use daily for years now and never miss a beat. When I was done programing the repeater I checked the rec and it was 1. tkr-7550

TKRE – (Discontinued) — Kenwood South Africa

If you have any questions, problems, or suggestions about Reviews, please email your Reviews Manager. Specify DC current settings at time of order. As for sensitivty I was disappointed. Modem kejwood to be used with LTR controllers, includes interface cable. Menwood is an option and cannot be sold separately. We have 2 others as stand alone repeaters, and 2 of the TKR The system is sometimes keyed up for hours on end, with no problems.


We purchased the models, but the higher split should work fine in the ham bands.

Kenwood Tkr Repeater VHF 16ch MHz 50 Watts | eBay

Still very happy with the Kenwoods. I will agree that the sensitivity could be better. Runs just fine and no heat issue. They seem as reliable. I wouldn’t put a pre amp up near an antenna for love or money. Audio is fantastic, and it is easy to implement an kenqood controller or accessory. I wound up using an Angle Linear GasFet preamp and a preselector to get it back up where it needed to be.

Includes equipment installation, hardware, cabling and wire management materials, and cushioned shipping crate. Clean, crisp audio otherwise.