International Intergard is a high build, high performance, two component epoxy with excellent chemical and abrasion resistance suitable for use as part of a. International Intergard is a high build high performance two component epoxy finish. Call Intergard should always be applied over a recommended primer coating scheme. The primer surface should be dry and free from all contamination, and.
Get in Touch with us Ashok Paint Agencies. Apply the Intergard within the overcoating interval specified for the primer, consult relevant primer data sheet. Please ensure you refer to all datasheets for full application information. International Intergard was not formulated to be used below water line, so we do not have any data. Coal Tar Epoxy Coatings. Take precautions to avoid skin and eye contact ie. Prior to use, obtain, consult and follow the Material Safety Data Sheet for this product concerning health and safety information.
Clean all equipment immediately after use with International GTA Prices are indicative only and may vary by country, with changes in raw materials prices or ihtergard rates. Where a cosmetic finish with good gloss and colour retention is required, overcoat with recommended top coats. All surfaces to be coated intfrgard be clean, dry and free from contamination. Customer agrees that before placing an Order, Customer has read and understood the most up to date Product Data Sheet for the Product.
Typical Coverage per coat. Coverage rates quoted are approximate, you agree that coverage depends on the condition of the substrate, surface absorption, texture and application method. We recommend that Customer first purchases the smallest Product available or access an industry standard colour chart in person and not digitally to ensure that the colour is acceptable for its purposes.
Apply in good weather. Suitable for use as part of intrrgard high performance coating system to provide an anti corrosive barrier in areas where aggressive corrosion conditions prevail. A high build, high performance, two component epoxy intermediate or finish with inttergard chemical and abrasion resistance. The question has been correctly sent.
International Intergard 410
Ensure that the area is clean and dry prior to application of Intergard Hi Can international intergard be used on the hull of a canal boat and how long before does it last before the boat needs to be taken out of the water to be done again. This product is no longer in stock. In common with all epoxy based coatings Intergard will exhibit chalking of the film on UV exposure.
Petersburg, Russia, phone: Other International Marine products Cosmetic Finishes. Water Based Epoxy Coating in Mumbai. Unmixed material in closed containers should be maintained in protected Storage in accordance with information given in the Storage Section of this data sheet.
Intergard 410 Epoxy Coating
Widely used in both new construction and industrial maintenance on off shore structures, chemical plants, power stations and pulp and paper plants. International Intergard Reference: Overcoating information is given for guidance only and is subject to regional variation depending upon local climate and environmental conditions. Get Best Price Request a quote.
Consult your local International Paint representative for specific recommendations. Do not exceed pot life Limitations.
International International Intergard is a high build, high performance, two component epoxy with excellent chemical and abrasion resistance suitable for use as part of a high performance coating system to provide an anti-corrosive barrier in areas where aggressive corrosion conditions prevail.
Intended uses For use on above water areas and in dry cargo holds as a high build intermediate or finish coat on structural steel, piping etc. Always mix a complete unit in the proportions supplied.
Technical and application data herein is for the purpose of establishing a general guideline of the coating application procedures. Nature of Business Wholesale Trader.
Intergard should always be applied over a recommended primer coating scheme. Material is supplied in two containers as a unit.
Thoroughly flush all equipment with International GTA Once units of paint have been mixed they should not be resealed and inteegard is advised that after prolonged stoppages work recommences with freshly mixed units. Products Marine Coatings Marine chemicals Integard lubricants.
Consult your International Paint representative for the system best suited for the surfaces to be protected.
Do not allow material to remain in hoses, gun or spray equipment. Recommended Tip Range 0. A two pack, high build epoxy intermediate or finish coat with good chemical and abrasion resistance. Get best deals for coconut.