Purchase your copy of ASTM E – 08() as a PDF download or hard copy directly from the official BSI Shop. All BSI British Standards. Standard Practice for Preparing Sulfur Prints for Macrostructural Examination – ASTM E /ER 2 Sulfur prints of as-cast specimens generally reveal the. For referenced ASTM standards, visit the ASTM website, , or.
The sulfur print complements macroetch methods by providing an additional procedure for evaluating the homogeneity of a steel product.
Standard Practice for Preparing Sulfur Prints for Macrostructural Examination
Steels with compositions that produce predominantly titanium or chromium sulfides will not produce useful images. The magnetite is formed by controlling the water chemistry and the temperature of fluid inside the facility. This paper presents a comparison of the mass loss rate of the tested materials between carbon steel A B and low alloy steel A P22 resulting from degradation effect.
The experimental facility allows examining aztm droplet impingement erosion in the same conditions as the secondary side piping in nuclear power plants by generating the magnetite on the surface of the test materials. No other units of measurement are included in this standard. In the initial stage of the experiments, the mass loss rate of A F1180 was greater than that of A P Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.
In nuclear power plants, carbon steel piping having experienced atm thinning degradation is generally replaced with low-alloy steel piping. The density of the print image should not be used to assess the sulfur content of a steel. The layer of magnetite on the surface of A is thicker than that of A P22, due to the different amount of chrome content. Selection of appropriate printing practices including selection of type of emulsion coated media, acid type and strength, will yield satisfactory prints.
ASTM E – 08 Standard Practice for Preparing Sulfur Prints for Macrostructural Evaluation
Historical Version s – view previous versions of standard. It has been thought that wall thinning on the secondary side piping in nu-clear power plants is mostly caused by Flow-Accelerated Corrosion FAC. For specific precautionary statements, see Section 9.
An experimental facility was set up to develop a prediction model for clarifying multiple degradation mechanisms that occur together. Very faint images in the sulfur print can be made more visible by scanning the sulfur print into a PC, and using a photo editor to increase the color saturation. It is presumed that the results are caused by the different yield strengths of the test materials and the different degrees of buffer action of the magnetite deposited on their surfaces.
ASTM E – 08() Standard Practice for Preparing Sulfur Prints for Macrostructural Evaluation
Under carefully controlled conditions, it is possible to compare print image intensities if the images are formed only by manganese sulfides. Scientific Research An Academic Publisher.
It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Link to Active This link will always route to the current Active version of the standard. Very low sulfur content steels will produce too faint an image to be useful for macrostructural evaluations.
However, the materials of pipes carrying two-phase flow should be selected considering their susceptibility to LDIE. However, after a certain period of time, the mass loss rate of A P22 became greater than that of A B.