D Standard Test Method for Indentation Hardness of Rigid Plastics by Means of a Barcol This Model fulfills the requirements of ASTM D and B Designation: D – 95 (Reapproved )e1An American National Standard Standard Test Method for Indentation Hardness of Rig. Buy ASTM D TEST METHOD FOR INDENTATION HARDNESS OF RIGID PLASTICS BY MEANS OF A BARCOL IMPRESSOR from.
Users of this test method should apply the principles outlined in Practice E to generate data speci? Data is expressed as Barcol numbers given by the instrument. Assurance Enabling you to identify and mitigate the intrinsic risk in your operations, supply chains and business processes.
Current edition approved October 10, The principles of dd2583 The following explanations of Ir and IR Impressions should not be made within 3 mm 1?
Barcol Hardness ASTM D2583
astn Summary of Test Method 4. Due to copyright restrictions, we are not able to provide copies of standards. Number of Readings Originally published as D — Each laboratory obtained three test results for each material.
The indicator should now read Eight plastic materials of different hardness were evaluated with six different Barcol Impressors.
This standard is subject to revision at any time by the responsible technical committee and must be reviewed every? Validating the specifications, value and safety of your raw materials, products and assets.
Through our network of over 43, people in 1, laboratories and offices in countries, Intertek provides quality and safety solutions to a wide range of industries around the world. Record the maximum reading. Send us a request Wilton UK: Place the Impressor and the material to be tested or the calibration disk on a solidly supported,?
The specimen is placed under the indentor of the Barcol hardness tester and a uniform pressure is applied to the specimen until the dial indication reaches a maximum. Any test specimen preparation, conditioning, dimensions, or testing parameters or combination thereof covered in the materials speci?
If these readings cannot be obtained, subsequent measurements are not valid. Testing Evaluating how your products and services meet and exceed quality, safety, sustainability and performance standards. Auditing Consulting Sourcing Training. Values below 10 using the Model Impressor are inexact and should not be reported. Global Reach Intertek is the industry leader with over 42, people in 1, locations in over countries.
Take care to avoid sliding or scraping while the indentor is in contact with the surface being tested.
If you feel that your comments have not received a fair hearing you should make your views known to the ASTM Committee on Standards, at the address shown below. Your comments are invited either for revision of this standard or for additional standards and should be addressed to ASTM International Headquarters. Need help or have a question?
Set the legs on the same surface or on solid material of the same thickness, so that the indentor is perpendicular to the surface being tested. If there are no material speci?
Nonhomogeneous Material Reinforced Plastics 30 40 50 60 70 Inspection Validating the specifications, value and safety of your raw materials, products and assets. Whether your business is local or global, we can ensure your products meet quality, health, environmental, safety, and social accountability standards for virtually any market around the world.
This greater variation may be caused mainly by the difference in hardness between resin and? Send us a request Need help or dd2583 a question?