Altek A Process Loop Calibrator, A Altek – on Sale at Test Equipment Depot. The Altek is no longer being manufactured. Update it with the PIE matching the Altek & A in fit, form and function with a few features bringing the. Altek Model A Loop Calibrator has been designed to check, calibrate, and troubleshoot all the signals present within a standard 4 to 20 milliamp process.
This feature is only found in PIE Calibrators! The Altek output voltage drops as the batteries run down. Calibration seals remain intact. Use at every point in zltek loop. The PIE matches the Altek in fit, form and function with a few features bringing the design into the 21st century.
Altek A-L-VIP mA Calibrator VIP Kit | Transcat
Simulate a changing process input to check loop response and control settings. Toggle the display to show milliamps or percent of 4 to Skip to content Altek Milliamp calibrator — no longer in production! Long Battery Life 3×9 volt alkaline batteries source 20 mA for over 20 hours, 12 mA for over 33 hours; 2-wire simulate and read for hours.
Altek calibrators come only with an unsigned Statement of Calibration Practices with a certificate of calibration available for an extra charge. View Cart My Account. The Model A measures 0. Recommended Replacement PIE The Altek A will check, calibrate and measure all your current signal instruments in a 4 to 20 milliamp DC loop.
Handy for checking transmitters in the field or on the bench. Why choose a PIE or Plus instead of some other brand of milliamp calibrator? Click for repair and calibration pricing.
Check controller outputs or measure the 334w signal anywhere in the loop.
Providing the finest test equipment solutions since 1992
Quik-Check Switch Select 4 or 20 mA output or 2-wire simulation. Or, if it is time to upgrade or replace a failing Altek calibrator, we offer a discount on a new PIE calibrator similar to the Altek that you are replacing — in working or non working condition! Replacing a different Altek Calibrator? Looking for more than just an Altek replacement?
Much longer than NiCd batteries or calibrators with a single 9 V battery! We are the same team that designed the Altek and the Altek A and no other manufacturer has as much milliamp calibrator experience as PIE.
Simultaneously measure the output 33a a 2-wire transmitter while using the internal batteries to supply up to 27V DC to power the transmitter. Easily set any value to within 0.
When it is time for service on your Altek milliamp calibrator PIE has the most experience in calibration and repair of Altek electronic calibrators. All 4 to 20 mA Loop Functions Source 0. It has a rubber boot and lower profile switches for protection in the field alltek a backlit display making it easier to use in the dark corners of your plant.
PIE also manufactures a complete line of milliamp, voltage, thermocouple, RTD and frequency single function calibrators as well as multifunction calibrators matching and surpassing the Altek line of 33a4 calibrators. The PIE has the same resolution and accuracy as the Altek with longer battery life letting you calibrate more instruments between battery changes.
The Altek was designed back in and the updated Altek A in Calibrate recorders, digital indicators, stroke valves or any other instruments that get their input from a 4 to 20 mA loop.
The “Quik-Chek” switch 33a rapid checking of 4. Check loop wiring and receivers by using the Model A in place of a 2-wire transmitter.