ABB ACS Operation Limits. Setup the For settings of other parameters/ macros and detailed explanation hereof, see the instructions manual from ABB. View and Download ABB ACS user manual online. ACS Controller pdf manual download. The ABB ACS series component drives are easy to select and come with a variety of standard features acsuser-manual-partpdf.
Mechanical installation What this chapter contains The chapter describes the mechanical installation procedure of the drive. Page 47 How to start, stop manuao switch between local and remote control You can start, stop and switch between local and remote control in any mode.
Page 39 Manial constant speeds drive output frequencies 1, 2 and 3 parametersand Check acceleration time and Read chapter Safety the first pages of this manual before you work on the drive.
ABB ACSACSACSACS Documentation
If not, contact an ABB representative. Never attempt to repair a malfunctioning drive; contact your local ABB representative or Authorized Service Center for replacement. Selects the application macro or activates FlashDrop parameter values. Motor Potentiometer Macro Motor Potentiometer macro This macro provides a cost-effective interface for PLCs that vary the speed of the drive using only digital signals.
Upper left — Control location: Ensure that the drive is in remote control. Before installation The ACS may be installed on the wall or in a cabinet. The minimum input signal runs the motor at the maximum reference in the reverse direction, the maximum input at the maximum reference in the forward direction.
Industrial Component Drives ACS150
You find the type code on the type designation label attached to the drive. Hardware Description The chapter describes the construction and type code information in short. Fuses must be used with other circuit breakers.
To prevent dependent overheating, set IR compensation voltage as low as possible. If acd150, physical injury or death may follow, or damage may occur to the drive, motor or driven equipment.
ABB ACS150 – 0.75KW – IP20 – ACS150-01E-04A7-2
Page Symbols Input continuous rms input current Output continuous rms current. A Value is at or above maximum limit.
Check acd150 enclosure requirements for the need to use the NEMA 1 option in wall installations see chapter Technical data. ABB Standard macro This is the default macro.
UL marking See the type designation label for the valid markings of your drive. Current and power The current and power ratings are given below. During the delay the drive knows accurately the rotor position. Compatibility The manual is compatible with the ACS drive firmware version 1. Motor cable shield To function as a protective conductor, the shield must have the same cross-sectional area as the phase conductors when they are made of the same metal.
Planning Electrical Installation Note: For example if XXX is 8A8, nominal current is 8.
Industrial Component Drives ACS | Variable Speed AC Motor Drive (ABB) | ECD Controls
Does not include short parameter list. Speed control of 3 to 50 hp 2.
It is used for setting the frequency reference. Safety What this chapter contains The chapter manul the safety instructions which you must follow when installing, operating and servicing the drive.
Page Stop drive suer change parameter value. Ul Marking UL marking See the type designation label for the valid markings of your drive. Corresponds to the minimum setting of the used source signal. Without plates R0 and R1 Page For the parameter default values, see section Default values with different macros on page Thermistor Contact your local ABB representative. Changed Parameters mode In the Changed Parameters mode, you can: