JIS G Hot-rolled high strength steel plate, sheet and strip with improved formability for automobile structural uses (FOREIGN. JIS G Hot-rolled high strength steel plates, sheet and strip with improved formability for automobile uses. Find the most up-to-date version of JIS G at Engineering
Magnetic flux density 2 T B50 B 1. T3134 email address is being protected from spambots. It is highly formable and delivers weight savings and increased component strength. The high-strength steel has good weldability and is used in automobile frames, members and wheels.
Jiw value is not applicable to the unstable portion at both ends of coils. The table is not applicable to a mill-edge steel sheet. This steel is widely used in floor applications, prevent skidding applications and fast drain water applications.
Atmospheric corrosion resistance and formability are also superior and weldability as well.
HR Sheets, Checkers & Plates
Please consult us particularly on the strength level. Figures in [ ] are for reference. Charpy absorption energy test is applied for plate in thickness over 12 mm.
Values to be added on the nominal thickness for calculation of mass Width Thickness 6. Grades are available with improved formability F on request. This type of steel with enhanced corrosion and atmosphere corrosion resistant properties through the addition of such special element as Cu, P and Cr is used in the manufacturing of containers, special jix and construction structures. Contact us Uncategorised Product Characteristics.
For the steel sheet under 8 mm in thickness, the elongation by No. This table is not applicable for both ends of coils. This can help you create lighter, stronger products and increase yield through down-gauging.
The total tolerance in this case shall be equal to that in the table. SPHT-1, 2, jid, 4. This steel, which has high-strength qualities and good formability, is used in high-pressure gas containers, with less than a litres inner capacity, used for holding LPG, acetylene, and other high-pressure gases.
Thickness tolerance is subject to the table below. We have helped many customers convert successfully to high-strength steels.
Bend test is performed with polished edges, bend line parallel to the rolling iis. Close this window and log in. International Standard TIS By joining you are opting in to receive e-mail.
For the width less than 40 mm, measuring shall be at the center of the width. The value specified in the above table shall be applied to jjis length of mm, and in the case of the 3.
NKCF Checkered floor plate This product has been produced since and, based upon such long experience, favored by many market fields for its jls, quality and performance.