FLYGT 3152 PDF

  • No Comments

2. C C Product. Submersible pump for pumping clean water, surface water and waste water containing solids or long-fibred material. Denomination. Dataplate. rpm. Max 40°C. YSER/Y//V. 26/51A. kWhp. Date: Flygt CS MT. Use our handy online form to submit details on your existing Flygt pump to get a Flygt C Submersible Pumps Range Flygt C LT Submersible.

Author: Daim Grojind
Country: Antigua & Barbuda
Language: English (Spanish)
Genre: History
Published (Last): 7 November 2014
Pages: 372
PDF File Size: 4.59 Mb
ePub File Size: 13.97 Mb
ISBN: 626-1-11497-419-8
Downloads: 12240
Price: Free* [*Free Regsitration Required]
Uploader: Tojazragore

The clearance between the impeller and the wear protection should be minimal. The pump is equipped with a connection for hose or pipe and stands on a base stand. Clean chemicals from the body 1. Flygt Installation, Operation, and Maintenance Manual 9 Transportation and Storage Lifting equipment The lifting flygr must fulfill the following requirements: The data plate lists key product specifications. The pipes and joints leak.

Connect the mains leads L1, L2, L3, and earth [ground] to the starter equipment. They are connected in series in the fflygt and activate the alarm at overtemperature.

Product specifications | Flygt 3152 – Alaska Pump and Supply

The installation is not receiving voltage. They are described below, if applicable. Check that all valves open correctly. Failure to do so could flyht in death or serious injury. The insulation between the phases and ground in the stator is defective. Personnel requirements Xylem disclaims all responsibility for work done by untrained and unauthorized personnel. Turn the pump so that the oil hole faces downwards.

  BMO RDSP PDF

Check the contactor and the control circuit. Do NOT use the pump in highly corrosive liquids. This applies to both ends of the motor cable. Take all necessary measures to avoid over-pressurization. Flyg the clearance between the impeller wear ring rotating and pump housing wear ring stationary exceeds 2mm 0.

When the pump is connected to the public power supply, it may cause flickering of incandescent lamps when started. The overload protection Check that the impeller can rotate 33152. Replace the valves, if necessary. Reset the valves that are set in the wrong position.

Flygt 3000 Series / C Submersible Pumps

Waste and emissions regulations Observe these safety regulations regarding waste and emissions: Special rules apply to installations in explosive atmospheres. The CLS sensor body is made of glass. The oil housing may be pressurized.

The wear ring in the pump housing 1. Clean the level regulators. There is a malfunction in the overload protection.

The starting jerk can be powerful. Replace all defective items. If necessary, saw grooves in the wear ring using a hacksaw.

  LOS DEBERES CICERON PDF

The impeller is difficult to rotate by hand.

The use of other parts can invalidate any claims for warranty or compensation. Install with S-installation In the S-installation, the pump is transportable and intended to operate either completely or partially submerged in the pumped liquid. Place the pump in a horizontal position. For more information, contact your Xylem representative VFD-supplier.

These requirements and instructions only apply when the installation is made according to the dimensional drawing. Condition-monitoring devices include but are not limited to these devices: Conduct a phase-to-phase resistance check. Observe these guidelines and warnings for electrical connections: Major overhaul To secure a long operating lifetime for the product.

Use the impeller puller or the crowbar.

Flygt – Alaska Pump and Supply |

Replace the impeller wear ring Figure Install the entrance cover and the O-ring on the stator housing. Do NOT override the motor protection repeatedly if it has tripped. Replace fuses that have tripped.

LL Figure