ASTM D6938 PDF

  • No Comments

ASTM D Standard Test Methods for In-Place Density and Water Content of Soil and Soil-Aggregate by Nuclear Methods (Shallow Depth). depth, etc.) Verify proper rebar sizes and placements. Verify proper reinforcing overlaps. Verify proper clearance and that chairs are. ASTM D Uploaded by Xavior. Standard Test Method for In-Place Density and Water Content of Soil and Soil- Aggregate by Nuclear Methods (Shallow.

Author: Kazikree Juzragore
Country: Madagascar
Language: English (Spanish)
Genre: Education
Published (Last): 19 September 2016
Pages: 246
PDF File Size: 17.24 Mb
ePub File Size: 20.58 Mb
ISBN: 123-2-54038-707-1
Downloads: 11408
Price: Free* [*Free Regsitration Required]
Uploader: Kajilrajas

In addition, they are representative of the significant digits that should generally be retained. Most gauges display this value directly. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.

For more information, contact: The neutron source and the thermal neutron detector are both located at the surface of the material being tested.

ASTM D Standard

The density of the test sample in mass per unit volume is calculated by comparing the detected rate of gamma radiation with previously established calibration data. The nondestructive nature allows repetitive measurements at a single test location and statistical analysis of the results.

It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Reliable results depend on many factors; Practice D provides a means of evaluating some of those factors.

  BARTOLOME DE LAS CASAS DEVASTATION OF THE INDIES PDF

Measurements for water moisture content are taken at the surface in backscatter mode regardless of the mode being used for density. The values in inch-pound units ft — lb units are provided for information only.

The water content most prevalent in engineering and construction activities is known as the gravimetric water content, w, and is the ratio of the mass of the water in pore spaces to the total mass of solids, expressed as a percentage.

The dry density 6d938 the test sample is obtained by subtracting the water mass per unit volume from the test sample wet density Section Link to Active This link will always route to the current Active version of the standard.

It is beyond the scope of this standard to consider significant digits used in analysis methods for engineering design.

ASTM D6938 – 17a

For Individuals with needing d69338 assistance for disabilities or limited English proficiency Please contact our Title VI specialist at The water mass per unit volume is determined by the thermalizing or slowing of fast neutrons by hydrogen, a component of water. This places the gamma and neutron sources and the detectors in the same plane.

  AIMCAT 1317 SOLUTIONS PDF

Soil testing Field Services: The quality of the result produced by asmt standard test method is dependent on the competence of the personnel performing it, and the suitability of the equipment and facilities used. When divided by the density of water and then multiplied bythe water mass per unit volume is equivalent to the volumetric water content.

ASTM D6938

The total or wet density of soil and soil-aggregate is measured by the attenuation of gamma radiation where, in direct transmission, the source is placed at a known depth up to mm 12 in. Request Quote Client Login.

Measurements for water moisture content are taken at the surface in backscatter mode regardless of the mode being used for density. Historical Version s – view previous versions of standard.

Soil testing Back to Results Print.

The direct transmission is the preferred method. Users of this standard are cautioned that compliance with Practice D does not in itself ensure reliable results. This test method describes the procedures for measuring in-place density and moisture of soil and soil-aggregate by use of nuclear equipment. Most gauges display this value directly.